AudioCodes Mediant 4000 SBC User Manual page 353

User's Manual
Parameter
Created By Routing Server
[IPGroup_CreatedByRouting
Server]
Used By Routing Server
used-by-routing-server
[IPGroup_UsedByRoutingSe
rver]
Proxy Set Connectivity
show voip proxy sets status
[IPGroup_ProxySetConnecti
vity]
Version 7.2
The valid value is a string of up to 100 characters. By default, no value
is defined.
Note:

If the parameter is not configured, the value of the global
parameter, ProxyName is used instead (see ''Configuring Proxy
and Registration Parameters'' on page 384).

The parameter overrides inbound message manipulation rules that
manipulate the host name in Request-URI, To, and/or From SIP
headers. If you configure the parameter and you want to
manipulate the host name in any of these SIP headers, you must
apply your manipulation rule (Manipulation Set ID) to the IP Group
as an Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is the
destination of the call. If you apply the Manipulation Set as an
Inbound Message Manipulation Set (see the
IPGroup_InboundManSet parameter), when the IP Group is the
source of the call, the manipulation rule is overridden by the SIP
Group Name parameter.
(Read-only) Indicates whether the IP Group was created by a third-
party routing server:

[0] No

[1] Yes
For more information on the third-party routing server feature, see
Centralized Third-Party Routing Server on page 278.
Enables the IP Group to be used by a third-party routing server for call
routing decisions.

[0] Not Used (default)

[1] Used
For more information on the third-party routing server feature, see
Centralized Third-Party Routing Server on page 278.
(Read-only field) Displays the connectivity status with Server-type IP
Groups. As the Proxy Set defines the address of the IP Group, the
connectivity check (keep-alive) by the device is done to this address.

"NA": Functionality is not applicable due to one of the following:

User-type IP Group.

Server-type IP Group, but the keep-alive mechanism of its'
associated Proxy Set is disabled.

"Not Connected": Keep-alive failure (i.e., no connectivity with the IP
Group).

"Connected": Keep-alive success (i.e., connectivity with the IP
Group).
The connectivity status is also displayed in the Topology View page
(see ''Building and Viewing SIP Entities in Topology View'' on page
372).
Note:

The feature is applicable only to Server-type IP Groups.

To support the feature, you must enable the keep-alive mechanism
of the Proxy Set that is associated with the IP Group (see
''Configuring Proxy Sets'' on page 363).

If the Proxy Set is configured with multiple proxies (addresses) and
353
Description
17. Control Network
Mediant 4000 SBC