User's Manual
Parameter
15.7.5 Configuring an HTTP-based OVOC Service
The OVOC Services table lets you configure a single HTTP-based OVOC service. For
more information on the OVOC service, see ''HTTP-based Proxy Services'' on page 282.
The following procedure describes how to configure an OVOC Service through the Web
interface. You can also configure it through ini file (EMSService) or CLI (configure network
> http-proxy ems-serv).
To configure an OVOC Service:
1.
Open the OVOC Services table (Setup menu > IP Network tab > HTTP Proxy folder
> OVOC Services).
2.
Click New; the following dialog box appears:
3.
Configure an OVOC Service according to the parameters described in the table below.
4.
Click Apply, and then save your settings to flash memory.
Table 15-23: OVOC Services Table Parameter Descriptions
Parameter
General
Index
[EMSService_Index]
Version 7.2
the associated TLS Context.
Note: The parameter is applicable only if the connection
protocol is HTTPS (defined using the 'Protocol' parameter,
above).
Figure 15-57: OVOC Services Table - Add Dialog Box
Defines an index number for the new table row.
Note:
Each row must be configured with a unique index.
The parameter is mandatory.
Description
Description
289
15. Services
Mediant 4000 SBC