Security Parameters; General Security Parameters - AudioCodes Mediant 4000 SBC User Manual

Parameter
configure network > high-
availability > net-mon-
enable
[HAPingEnabled]
Destination Address
configure network > high-
availability > net-mon-
destination
[HAPingDestination]
Source Interface Name
configure network > high-
availability > net-mon-
source-interface
[HAPingSourceIfName]
Ping Timeout
configure network > high-
availability > net-mon-ping-
timeout
[HAPingTimeout]
Ping Retries
configure network > high-
availability > net-mon-ping-
retries
[HAPingRetries]
60.5

Security Parameters

This subsection describes the device's security parameters.

60.5.1 General Security Parameters

The general security parameters are described in the table below.
Parameter
Firewall Table
Firewall
configure network > access-list
[AccessList]
User's Manual
test reachability from one of the device's IP network interfaces. If no
reply is received from a ping and the previous ping was successful, a
switchover occurs to the redundant device.

[0] Disable (default)

[1] Enable
Defines the IP address of the destination that the device pings.
The default is 0.0.0.0.
Defines the device's IP network interface from where the ping is sent.
The valid value is the name of the IP interface as configured in the
'Interface Name' field of the IP Interfaces table. By default, no IP network
is defined.
Defines the timeout (in seconds) for which the ping request waits for a
reply.
The valid value is 1 to 60. The default is 1.
Defines the number of ping requests that the device sends after no
response is received from the destination, before the destination is
declared unavailable. For example, if you specify 2, the destination is
declared as down after three consecutive ping requests fail to evoke a
response from the destination.
The valid value is 0 to 100. The default 2.
Table 60-22: General Security Parameters
The table defines the device's access list (firewall), which defines
network traffic filtering rules.
The format of the ini file table parameter is:
[AccessList]
FORMAT AccessList_Index = AccessList_Source_IP,
AccessList_Source_Port, AccessList_PrefixLen,
AccessList_Source_Port, AccessList_Start_Port,
AccessList_End_Port, AccessList_Protocol,
838
Description
Description
Document #: LTRT-40203
Mediant 4000 SBC