AudioCodes Mediant 4000 SBC User Manual page 54

3. Click Apply to add the row to the table or click Cancel to ignore your configuration.
4. If the Save
settings to flash memory, otherwise they are discarded if the device resets (without a
save to flash) or powers off.
6.1.6.1.1 Assigning Rows from Other Tables
Some tables contain parameters whose value is an assigned row (referenced-row) from
another table (referenced-table). For example, the IP Groups table contains the 'Proxy Set'
parameter whose value is an assigned Proxy Set, configured in the Proxy Sets table.
These parameter types provide a drop-down list for selecting the value and a View button,
as shown in the example below:
You can assign a referenced-row using one of the following methods:

Selecting a referenced-row from the drop-down list:
•
Scroll down to the desired item and click it.
•
Search for the item by entering in the field the first few characters of the desired
row, and then clicking it. The figure below shows an example of searched results
for items (Proxy Sets) that begin with the letter "i":

Selecting an existing referenced-row directly from the referenced-table:
a. Click View; the table (e.g., IP Groups table) and dialog box in which the button
was clicked is minimized to the bottom-left corner of the Web interface and the
referenced-table (e.g., Proxy Sets table) opens.
b. Add a new row (e.g., Proxy Set), if required; otherwise, skip this step.
c. Select the desired row in the row-referenced table (e.g., Proxy Sets table), and
then click Use selected row located on the top-right of the table, as shown in the
example below:

Adding a new referenced-row:
User's Manual
button is surrounded by a red border, you must save your
Figure 6-6: Parameter with View Button (Example)
Figure 6-7: Searching a Row to Reference
Figure 6-8: Selecting Referenced Row
54
Mediant 4000 SBC
Document #: LTRT-40203