AudioCodes Mediant 4000 SBC User Manual page 510

Parameter
Routing Tag Name
routing-tag-name
[IP2IPRouting_RoutingTag
Name]
Internal Action
internal-action
[IP2IPRouting_InternalActi
on]
User's Manual
To configure Cost Groups, see ''Configuring Cost Groups'' on page 267.
Note:

To implement LCR and its Cost Groups, you must enable LCR for the
Routing Policy assigned to the routing rule (see ''Configuring SBC
Routing Policy Rules'' on page 518). If LCR is disabled, the device
ignores the parameter.

The Routing Policy also determines whether matched routing rules
that are not assigned Cost Groups are considered as a higher or
lower cost route compared to matching routing rules that are
assigned Cost Groups. For example, if the 'Default Call Cost'
parameter in the Routing Policy is configured to Lowest Cost, even if
the device locates matching routing rules that are assigned Cost
Groups, the first-matched routing rule without an assigned Cost
Group is considered as the lowest cost route and thus, chosen as the
preferred route.
Defines the destination Dial Plan tag, which is used to determine the
destination IP Group.
The default value is "default", meaning that the device uses the first tag
name in the Dial Plan rule that is configured without a value. For
example, if the Dial Plan rule is configured with tags
"Country=England;City=London;Essex", the default tag is "Essex".
For more information, see Using Dial Plan Tags for Routing Destinations
on page page 551.
Note:

The parameter is applicable only if the 'Destination Type' parameter
is configured to Destination Tag (see above).

Only one tag can be configured for the parameter.

Only the tag name must be configured (not the value, if exists). For
example, if the tag is configured in the Dial Plan rule as
"Country=England", configure the parameter to "Country" only.
Defines a SIP response code (e.g., 200 OK) or a redirection response
(with an optional Contact field indicating to where the sender must re-
send the message) that the device sends to the sender of the incoming
SIP dialog (instead of sending the call to another destination). The
parameter is applicable only when the 'Destination Type' parameter in
this table is configured to Internal (see above).
The valid value syntax is (case-insensitive):

For SIP response codes:
Reply(response='<code>')
The following example sends a SIP 200:
Reply(response='200')

For redirection responses:
Redirect (response='<code>', contact='sip:'+....)
Redirect (contact='...', response = '<code>')
Redirect (contact = 'sip:user@host')
Examples:

The device responds to the dialog with a SIP 300 redirect
response that includes a contact value:
Redirect (response='300', contact='sip:102@host')

The device redirects the call from the sender to a SIP Recording
510
Description
Document #: LTRT-40203
Mediant 4000 SBC