AudioCodes Mediant 4000 SBC User Manual page 168

Parameter
Start Port
start-port
[AccessList_Start_Port]
End Port
end-port
[AccessList_End_Port]
Protocol
protocol
[AccessList_Protocol]
Use Specific Interface
use-specific-interface
[AccessList_Use_Specific_Interface]
Interface Name
network-interface-name
[AccessList_Interface_x]
Action
Action Upon Match
allow-type
[AccessList_Allow_Type]
Packet Size
packet-size
User's Manual
this value to any of the above options.
Note: A value of 0 applies to all packets, regardless of the
defined IP address. Therefore, you must set the parameter to a
value other than 0.
Defines the first UDP/TCP port in the range of ports on the
device on which the incoming packet is received. From the
perspective of the remote IP entity, this is the destination port.
To configure the last port in the range, see the 'End Port'
parameter (below).
The valid range is 0 to 65535.
Note: When the protocol type isn't TCP or UDP, the entire
range must be provided.
Defines the last UDP/TCP port in the range of ports on the
device on which the incoming packet is received. From the
perspective of the remote IP entity, this is the destination port.
To configure the first port in the range, see the 'Start Port'
parameter (above).
The valid range is 0 to 65535 (default).
Note: When the protocol type isn't TCP or UDP, the entire
range must be provided.
Defines the protocol type (e.g., UDP, TCP, ICMP, ESP or Any)
or the IANA protocol number in the range of 0 (Any) to 255.
The default is Any.
Note: The parameter also accepts the abbreviated strings
"SIP" and "HTTP". Specifying these strings implies selection of
the TCP or UDP protocols and the appropriate port numbers
as defined on the device.
Determines whether you want to apply the rule to a specific
network interface defined in the IP Interfaces table (i.e.,
packets received from that defined in the Source IP field and
received on this network interface):

[0] Disable (default)

[1] Enable
Note:

If enabled, then in the 'Interface Name' field (described
below), select the interface to which the rule is applied.

If disabled, then the rule applies to all interfaces.
Defines the network interface to which you want to apply the
rule. This is applicable if you enabled the 'Use Specific
Interface' field. The list displays interface names as defined in
the IP Interfaces table in ''Configuring IP Network Interfaces''
on page 129.
Defines the firewall action to be performed upon rule match.

"Allow" = (Default) Permits the packets.

"Block" = Rejects the packets
Defines the maximum allowed packet size.
The valid range is 0 to 65535.
168
Mediant 4000 SBC
Description
Document #: LTRT-40203