Quality Of Experience Parameters - AudioCodes Mediant 4000 SBC User Manual

Parameter
Primary Server IP
configure network > ocsp >
server-ip
[OCSPServerIP]
Secondary Server IP
configure network > ocsp >
secondary-server-ip
[OCSPSecondaryServerIP]
Server Port
configure network > ocsp >
server-port
[OCSPServerPort]
Default Response When
Server Unreachable
configure network > ocsp >
default-response
[OCSPDefaultResponse]
60.6

Quality of Experience Parameters

The Quality of Experience (QoE) parameters are described in the table below.
Parameter
OVOC Parameters
Server IP
configure voip > qoe
settings > server-ip
[QOEServerIP]
Redundant Server IP
configure voip > qoe
settings > redundant-
server-ip
[QOESecondaryServerIp]
Interface Name
configure voip > qoe
settings > interface-name
[QOEInterfaceName]
QoE Connection by TLS
configure voip > qoe
settings > tls-enable
[QOEEnableTLS]
User's Manual
Checking (OCSP).
Defines the IP address of the OCSP server.
The default IP address is 0.0.0.0.
Defines the IP address (in dotted-decimal notation) of the secondary
OCSP server (optional).
The default IP address is 0.0.0.0.
Defines the OCSP server's TCP port number.
The default port number is 2560.
Determines whether the device allows or rejects peer certificates
when the OCSP server cannot be contacted.

[0] Reject (default)

[1] Allow
Table 60-29: Quality of Experience Parameters
Defines the IP address of the primary One Voice Operations Center
(OVOC) server to where the quality experience reports are sent.
Note: For the parameter to take effect, a device reset is required.
Defines the IP address of the secondary OVOC server to where the
quality experience reports are sent. This is applicable when the OVOC
server is in Geographical Redundancy HA mode.
Note: For the parameter to take effect, a device reset is required.
Defines the IP network interface on which the quality experience reports
are sent.
The default is the OAMP interface.
Note: For the parameter to take effect, a device reset is required.
Enables a TLS connection with the OVOC server.

[0] Disable (default)

[1] Enable
Note: For the parameter to take effect, a device reset is required.
848
Description
Description
Document #: LTRT-40203
Mediant 4000 SBC