AudioCodes Mediant 4000 SBC User Manual page 128

The following procedure describes how to configure Ethernet Devices through the Web
interface. You can also configure it through ini file (DeviceTable) or CLI (configure network
> network-dev).

To configure an Ethernet Device:
1. Open the Ethernet Devices table (Setup menu > IP Network tab > Core Entities
folder > Ethernet Devices).
2. Click New; the following dialog box appears:
3. Configure an Ethernet Device according to the parameters described in the table
below.
4. Click Apply.
Table 11-4: Ethernet Devices Table Parameter Descriptions
Parameter
Index
[DeviceTable_Index]
Name
name
[DeviceTable_DeviceName]
VLAN ID
vlan-id
[DeviceTable_VlanID]
Underlying Interface
underlying-if
[DeviceTable_UnderlyingInterface]
Tagging
tagging
[DeviceTable_Tagging]
User's Manual
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines a name for the Ethernet Device. The name is used to
associate the Ethernet Device with an IP network interface in the
IP Interfaces table ('Underlying Device' field - see ''Configuring IP
Network Interfaces'' on page 129) and/or with a static route in the
Static Routes table ('Device Name' field - see ''Configuring Static
IP Routing'' on page 137).
Defines a VLAN ID for the Ethernet Device.
The valid value is 1 to 3999. The default is 1.
Note: Each Ethernet Device must have a unique VLAN ID.
Assigns an Ethernet Group to the Ethernet Device. To configure
Ethernet Groups, see Configuring Ethernet Port Groups on page
125.
Note: The parameter is mandatory.
Defines VLAN tagging for the Ethernet Device.

[0] Untagged = (Default for pre-configured Ethernet Device)
The Ethernet Device accepts untagged packets and packets
with the same VLAN ID as the Ethernet Device. Incoming
128
Mediant 4000 SBC
Description
Document #: LTRT-40203