Configuration Parameters Reference; Management Parameters; General Parameters - AudioCodes Mediant 4000 SBC User Manual

User's Manual
60

Configuration Parameters Reference

The device's configuration parameters, default values, and their descriptions are
documented in this section.
Note:
parameters and their enumeration values.
60.1

Management Parameters

This section describes the device's management-related parameters.

60.1.1 General Parameters

The general management parameters are described in the table below.
Parameter
[WebLoginBlockAutoComplete] Disables autocompletion when entering the management login
[EnforcePasswordComplexity]
[CustomerSN]
Access List Table
configure network >
access-list
[WebAccessList_x]
Version 7.2
Parameters and values enclosed in square brackets [...] represent the ini file
Table 60-1: General Management Parameters
username in the 'Username' field of the device's Web interface.
Disabling autocompletion may be useful for security purposes by
hiding previously entered usernames and thereby, preventing
unauthorized access to the device's management interface.

[0] Disable = (Default) Autocompletion is enabled and the
'Username' field automatically offers previously logged in
usernames.

[1] Enable = Autocompletion is disabled.
Enables the enforcement of management login-password
complexity requirements to ensure strong passwords.

[0] Disable (default)

[1] Enable
For more information on password complexity requirements, see
the 'Password' parameter in Configuring Management User
Accounts on page 69.
Defines a serial number (S/N) for the device.
Note: The device's original S/N is automatically added at the end
of the configured S/N. For example, if the original S/N is 8906721
and the configured S/N is "abc123", the resultant S/N is
"abc1238906721".
This table configures up to ten IP addresses that are permitted to
access the device's Web interface and Telnet interfaces. Access
from an undefined IP address is denied. When no IP addresses
are defined in this table, this security feature is inactive (i.e., the
device can be accessed from any IP address).
The default is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
60. Configuration Parameters Reference
Description
803 Mediant 4000 SBC