AudioCodes Mediant 4000 SBC User Manual page 522

Table 25-4: Routing Policies table Parameter Descriptions
Parameter
General
Index
Name
name
[SBCRoutingPolicy_Name]
LDAP Servers Group Name
ldap-srv-group-name
[SBCRoutingPolicy_LdapS
erversGroupName]
Least Cost Routing
LCR Feature
lcr-enable
[SBCRoutingPolicy_LCREnable
]
Default Call Cost
lcr-default-cost
[SBCRoutingPolicy_LCRDefault
Cost]
LCR Call Duration
lcr-call-length
[SBCRoutingPolicy_LCRAverag
eCallLength]
User's Manual
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Defines a descriptive name, which is used when associating the
row in other tables.
The valid value is a string of up to 40 characters. By default, no
name is defined. If you don't configure a name, the device
automatically assigns a name in the following format:
"SBCRoutingPolicy_<Index>", for example, "SBCRoutingPolicy_2".
Note: Each row must be configured with a unique name.
Assigns an LDAP Server Group to the Routing Policy. Routing
rules in the IP-to-IP Routing table that are associated with the
Routing Policy and that are configured with LDAP and/or Call
Setup Rules, use the LDAP server(s) configured for this LDAP
Server Group.
By default, no value is defined.
For more information on LDAP Server Groups, see ''Configuring
LDAP Server Groups'' on page 240.
Note: The default Routing Policy is assigned the default LDAP
Server Group ("DefaultCTRLServersGroup").
Enables the Least Cost Routing (LCR) feature for the Routing
Policy.

[0] Disable (default)

[1] Enable
For more information on LCR, see ''Least Cost Routing'' on page
265.
Defines whether routing rules in the IP-to-IP Routing table that are
not assigned a Cost Group are considered a higher cost or lower
cost route compared to other matched routing rules that are
assigned Cost Groups.

[0] Lowest Cost = (Default) The device considers a matched
routing rule (belonging to the Routing Policy) that is not
assigned a Cost Group as the lowest cost route. Therefore, it
uses the routing rule.

[1] Highest Cost = The device considers a matched routing rule
(belonging to the Routing Policy) that is not assigned a Cost
Group as the highest cost route. Therefore, it is only used if the
other matched routing rules that are assigned Cost Groups are
unavailable.
Note: If multiple matched routing rules without an assigned Cost
Group exist, the device selects the first matched rule in the table.
Defines the average call duration (in minutes) and is used to
calculate the variable portion of the call cost. This is useful, for
example, when the average call duration spans over multiple time
bands. The LCR is calculated as follows: cost = call connect cost +
(minute cost * average call duration).
522
Mediant 4000 SBC
Description
Document #: LTRT-40203