Configuring Secured (Https) Web - AudioCodes Mediant 4000 SBC User Manual

User's Manual

To change the login password:
1. Open the Web Settings page (Setup menu > Administration tab > Web & CLI folder
> Web Settings).
Figure 6-35: Changing Login Password for Administrator and Monitor User Levels
2. In the 'Current Password' field, type in your current login password.
3. In the 'New Password' field, type in your new password.
4. In the 'Confirm New Password' field, type in your new password again.
5. Click Change; you are logged off the Web session and prompted to login in again with
your new login password.
6.9

Configuring Secured (HTTPS) Web

By default, the device allows remote management (client) through HTTP and HTTPS.
However, you can enforce secure Web access communication by configuring the device to
accept only HTTPS.

To configure secure (HTTPS) Web access:
1. Open the Web Settings page (Setup menu > Administration tab > Web & CLI folder
> Web Settings).
2. Under the General group, configure the following:
3. From the 'Secured Web Connection (HTTPS)' drop-down list, select HTTPS Only.
4. To enable two-way authentication whereby both management client and server are
authenticated using X.509 certificates, from the 'Require Client Certificates for HTTPS
connection' drop-down list, select Enable.
5. In the 'HTTPS Cipher String' field, enter the cipher string for HTTPS (in OpenSSL
cipher list format).
6. Click Apply, and then reset the device with a save-to-flash for your settings to take
effect.
For more information on secure Web-based management including TLS certificates, see
''TLS for Remote Device Management'' on page 116.
Version 7.2 77
6. Web-Based Management
Mediant 4000 SBC