Configuring Message Condition Rules - AudioCodes Mediant 4000 SBC User Manual

Parameter
action-value
[MessageManipulations_Action
Value]
19.2

Configuring Message Condition Rules

The Message Conditions table lets you configure up to 500 Message Condition rules. A
Message Condition defines special conditions (requisites) for incoming SIP messages.
These rules can be used as additional matching criteria for the following:

Classification rules in the Classification table (see ''Configuring Classification Rules''
on page 491)

IP-to-IP routing rules in the IP-to-IP Routing table (see ''Configuring SBC IP-to-IP
Routing Rules'' on page 499)

Outbound Manipulation rules in the Outbound Manipulations table (see ''Configuring
IP-to-IP Outbound Manipulations'' on page 533)
Message Condition rules are configured using the same syntax as that used for Conditions
when configuring Message Manipulation rules in the Message Manipulations table (see
''Configuring SIP Message Manipulation'' on page 395). You can configure simple Message
Condition rules, for example, "header.to.host contains company", meaning SIP messages
whose To header has a host part containing the string "company". You can configure
complex rules using the "AND" or "OR" Boolean operands and also use regular
expressions (regex), for example:

"body.sdp regex pcmu" can be used to enable routing based on the offered codec
(G.711 Mu) in the incoming SDP message.

"body.sdp regex (AVP[0-9||\s]*\s8[\s||\n])" can be used to enable routing based on
payload type 8 in the incoming SDP message.
Note: For a description on SIP message manipulation syntax, refer to the SIP
Message Manipulations Quick Reference Guide.
The following procedure describes how to configure Message Condition rules through the
Web interface. You can also configure it through ini file (ConditionTable) or CLI (configure
voip > sbc routing condition-table).

To configure a Message Condition rule:
1. Open the Message Conditions table (Setup menu > Signaling & Media tab >
Message Manipulation folder > Message Conditions).
User's Manual
syntax:

string/<message-element>/<call-param> +

string/<message-element>/<call-param>
For example:

'itsp.com'

header.from.url.user

param.call.dst.user

param.call.dst.host + '.com'

param.call.src.user + '<' + header.from.url.user + '@' +
header.p-asserted-id.url.host + '>'
Note: Only single quotation marks must be used.
400
Mediant 4000 SBC
Description
Document #: LTRT-40203