AudioCodes Mediant 4000 SBC User Manual page 785

User's Manual
Parameter
IP Group
ip-group-id
[Test_Call_IPGroupName]
Destination Address
dst-address
[Test_Call_DestAddress]
SIP Interface
sip-interface-name
[Test_Call_SIPInterfaceName]
Application Type
application-type
[Test_Call_ApplicationType]
Destination Transport Type
dst-transport
[Test_Call_DestTransportType]
QoE Profile
qoe-profile
[Test_Call_QOEProfile]
Bandwidth Profile
bandwidth-profile
Version 7.2

[2] Dest Address = Calls are matched by (or routed to) a
destination IP address. To configure the address, see the
'Destination Address' parameter in the table.
Note:

If configured to Dest Address, you must assign a SIP Interface
(see the 'SIP Interface' parameter in the table).

For REGISTER messages:

If configured to IP Group, only Server-type IP Groups can
be used.
Assigns an IP Group. This is the IP Group that the test call is sent to
or received from.
By default, no value is defined.
To configure IP Groups, see ''Configuring IP Groups'' on page 349.
Note:

The parameter is applicable only if you configure the 'Route By'
parameter to IP Group.

The IP Group is used for incoming and outgoing calls.
Defines the destination host.
The valid value is an IP address[:port] or DNS name[:port].
Note: The parameter is applicable only if the 'Route By' parameter
is configured to Dest Address [2].
Assigns a SIP Interface. This is the SIP Interface to which the test
call is sent and received from.
By default, no value is defined.
To configure SIP Interfaces, see Configuring SIP Interfaces on page
341.
Note: The parameter is applicable only if the 'Route By' parameter
is configured to Dest Address.
Defines the application type for the endpoint. This associates the IP
Group and SRD to a specific SIP interface.

[2] SBC = SBC application
Note: The parameter must always be set to SBC [2].
Defines the transport type for outgoing calls.

[-1] = Not configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: The parameter is applicable only if the 'Route By' parameter
is set to Dest Address.
Assigns a QoE Profile to the test call.
By default, no value is defined.
To configure QoE Profiles, see ''Configuring Quality of Experience
Profiles'' on page 311.
Assigns a Bandwidth Profile to the test call.
By default, no value is defined.
To configure Bandwidth Profiles, see ''Configuring Bandwidth
785
57. Testing SIP Signaling Calls
Description
Mediant 4000 SBC