AudioCodes Mediant 4000 SBC User Manual page 272

Note:
•
You can configure only one Remote Web Service for each of the following server
types: Routing, Call Status, Topology Status, and QoS.
•
The Routing service also includes the Call Status and Topology Status services.
•
You can configure up to four Remote Web Services for Capture. However, the
Capture service is currently not supported.
•
The device supports HTTP redirect responses (3xx) only during connection
establishment with the host. Upon receipt of a redirect response, the device
attempts to open a new socket with the host and if this is successful, closes the
current connection.
The following procedure describes how to configure Remote Web Services through the
Web interface. You can also configure it through ini file (HTTPRemoteServices) or CLI
(configure system > http-services > http-remote-services).

To configure a remote Web service:
1. Open the Remote Web Services table (Setup menu > IP Network tab > Web
Services folder > Remote Web Services).
2. Click New; the following dialog box appears:
Figure 15-45: Remote Web Services Table - Add Dialog Box
3. Configure a remote Web service according to the parameters described in the table
below.
4. Click Apply, and then save your settings to flash memory.
Table 15-18: Remote Web Services Table Parameter Descriptions
Parameter
General
Index
[HTTPRemoteServices_Index]
User's Manual
Defines an index number for the new table row.
Note:

Each row must be configured with a unique index.
272
Mediant 4000 SBC
Description
Document #: LTRT-40203