Configuring Ad-Based Routing Rules - AudioCodes Mediant 4000 SBC User Manual

User's Manual
15.4.12.2

Configuring AD-Based Routing Rules

The following procedure describes how to configure outbound IP routing based on LDAP
queries.

To configure LDAP-based IP routing for Skype for Business:
1. Configure the LDAP server parameters, as described in ''Configuring LDAP Servers''
on page 242.
2. Configure the AD attribute names used in the LDAP query:
a. Open the SIP Definitions General Settings page (Setup menu > Signaling &
Media tab > SIP Definitions folder > SIP Definitions General Settings).
Figure 15-43: LDAP Parameters for Microsoft Skype for Business
b. Configure the LDAP attribute names as desired.
3. Configure query-result routing rules for each IP domain (private, PBX / IP PBX, Skype
for Business clients, and mobile), using the LDAP keywords (case-sensitive) for the
prefix destination number:
4. Configure AD-based IP-to-IP routing rules:
a. Open the IP-to-IP Routing table (see Configuring SBC IP-to-IP Routing Rules on
page 499).
b. Configure query-result routing rules for each IP domain (private, PBX / IP PBX,
Skype for Business clients, and mobile), using the LDAP keywords (case-
sensitive) in the Destination Username Prefix field:
♦
♦
♦
♦
♦
c. Configure a routing rule for routing the initial call (LDAP query) to the LDAP
server, by setting the 'Destination Type' field to LDAP for denoting the IP address
of the LDAP server.
d. For alternative routing, enable the alternative routing mechanism and configure
corresponding SIP reasons for alternative routing. For this feature, alternative
routing starts from the table row located under the LDAP query row.
Version 7.2
PRIVATE: Private number
OCS: Skype for Business client number
PBX: PBX / IP PBX number
MOBILE: Mobile number
LDAP_ERR: LDAP query failure
263
15. Services
Mediant 4000 SBC