■ Procedure
1. Remove the reader relay PCB.
• 3 flexible cables
• 4 connectors
• 6 screws
7x
Removing the Power Supply
PCB
■ Preparation
1. Remove the inside base
Base Cover" on page 133
2. Remove the left rear
Cover" on page 134
3. Remove the left
cover."Removing the Left Cover" on
page 132
■ Procedure
1. Disconnect all connectors on the power supply PCB.
6x
cover."Removing the Inside
cover."Removing the Left Rear
2. Remove the power supply PCB.
• 3 screws
3x
NOTE:
In the case of the Europe model, the following procedure
is necessary.
• 1 connector
• 2 clamps
1x
Removing the DC Controller
PCB
■ Before Replacement/RAM Clearing
Print the service data list in the service mode.
• REPORT > REPORT OUTPUT > SERVICE DATA LIST
■ Preparation
1. Remove the rear cover
Cover (Right)" on page 136
2. Remove the rear cover
Cover (Left)" on page 137
172
4. Disassembly/Assembly
2x
(right)."Removing the Rear
(left)."Removing the Rear