Table of Contents
Advertisement
DMS-1250 Series Multi-G Ethernet Smart Managed Switch Hardware Installation Guide
Figure 1-4 DMS-1250-10SPL
Ports
Ports that can be found on the front panel of this switch are listed in the table below.
Port
Console
100/1000/2.5GBASE-T RJ45
Ports
100/1000/2.5GBASE-T RJ45
PoE Ports
10 Gigabit SFP+ Ports
100/1000/2.5G/5G/10GBASE-
T RJ45 Ports
CAUTION: This equipment is to be connected only to PoE networks without routing to the outside plant.
ATTENTION : Cet équipement ne doit être connecté qu'à des réseaux PoE sans routage vers l'extérieur.
For a complete list of SFP/SFP+ transceivers that are compatible with this switch, refer to the SFP+ Ports section in
Port Functions.
Reset Button
On the front panel of the Switch is a Reset button. The Switch will reboot or reset to factory default settings depending
on how long this button is pressed.
• Press and hold the Reset button for less than 5 seconds (release before 5 seconds) to reboot the Switch. All
unsaved configurations will be lost.
• Press and hold the Reset button for more than 5 seconds (release between 6 and 10 seconds or above) to
reset the software configuration of the Switch to the factory default settings. All the port LEDs will light up (solid
amber) for 2 seconds to indicate the start of the factory reset procedure.
Figure 1-3. DMS-1250-12TP
Description
The RJ45 console port can be used to connect to the command line interface (CLI)
of the switch for configuration, management and monitoring (for DMS-1250-
10S/DMS-1250-10SP/DMS-1250-12TP).
The DMS-1250 series Switches are equipped with 2.5GE RJ45 Ethernet ports.
These ports can operate at 100Mbps, 1Gbps and 2.5Gbps wire-speeds.
DMS-1250-10SP, DMS-1250-12TP and DMS-1250-10SPL Switches are equipped
with 8 RJ45 PoE Ethernet ports. These ports can operate at 100 Mbps, 1 Gbps
and 2.5 Gbps wire-speeds and support PoE function.
The Switch is equipped with SFP+ ports. These ports can operate at 1 Gbps and
10 Gbps wire-speeds and support a wide collection of SFP/SFP+ transceivers.
The DMS-1250-12TP Switch supports 2 RJ45 10 Gbps Ethernet ports. These
ports can operate at 100, 1000, 2500, 5000 and 10000 Mbps wire speeds.
3
Advertisement
Table of Contents
