Table of Contents
Advertisement
DIS-700G-28SW Industrial Layer 2+ Gigabit Managed Switch with SFP slots
CLI Initialization & Configuration (Optional)
1.
Connecting to DIS-700G-28SW Ethernet port (RJ45 Ethernet port).
2.
Enter the command: telnet 192.0.2.1
3.
Login with default account and password.
Username: admin
Password: admin
4.
Change the IP address with commands listed below:
CLI Command:
enable
configure
interface vlan 1
ip-address xxx.xxx.xxx.xxx netmask xxx.xxx.xxx.xxx
exit
SYSTEM RESET
The Reset button is provided to reboot the system without the need to remove power. Under normal
circumstances, you will not have to use it. However, or rare occasions, the DIS-700G-28SW may not
respond; then you may need to push the Reset button.
Quick Installation Guide
8
Advertisement
Table of Contents
