DGS-1250 Series Gigabit Ethernet Smart Managed Switch CLI Reference Guide
Example
This example shows how to reboot the Switch.
Switch#reboot force_agree
Please wait, the switch is rebooting...
2-14
reset system
This command is used to reset the system, clear the system's configuration, and then save and reboot the Switch.
reset system
Parameters
None.
Default
None.
Command Mode
EXEC Mode.
Usage Guideline
Use this command to clear the system's configuration. The configuration data will revert to the default settings,
save it to the start-up configuration file, and then reboot the Switch. Before using this command, save a backup of
the configuration using the copy command or upload the configuration profile to the TFTP server.
Example
This example shows how to reset the system to the factory default settings.
Switch#reset system
This command will clear the system's configuration to the factory
default settings, including the IP address.
Clear system configuration, save, reboot? (y/n) [n]
Saving configurations and logs to NV-RAM...... 100 %
Please wait, the switch is rebooting...
2-15
ip route
This command is used to create a static route entry. Use the no form of this command to remove a static route
entry.
ip route NETWORK-PREFIX NETWORK-MASK IP-ADDRESS [primary | backup]
no ip route NETWORK-PREFIX NETWORK-MASK IP-ADDRESS
y
17