Reset Button; Led Indicators - D-Link DGS-1250 Series Hardware Installation Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide

Reset Button

On the front panel of the Switch is a Reset button. The Switch will reboot or reset to factory default settings depending
on how long this button is pressed.
• Press and hold the Reset button for less than 5 seconds (release before 5 seconds) to reboot the Switch. All
unsaved configurations will be lost.
• Press and hold the Reset button for more than 5 seconds (release between 6 and 10 seconds) to reset the
software configuration of the Switch to the factory default settings. All the port LEDs will light up (solid amber)
for 2 seconds to indicate the start of the factory reset procedure.

LED Indicators

Located on the front panel of this switch are LED indicators: Power, Console, Fan Error, and Link/Act indicators for all
the ports. The DGS-1250-28XMP and DGS-1250-52XMP switches are equipped with Power Max., PoE indicators for
all the ports, and Link/Act and PoE indicators for mode selection.
LED
Power
Console
Figure 1-5 LED indicators for the DGS-1250-28X
Figure 1-6 LED indicators for the DGS-1250-28XMP
Figure 1-7 LED indicators for the DGS-1250-52X
Figure 1-8 LED indicators for the DGS-1250-52XMP
Description
This LED will light solid green after the Switch has been powered on successfully.
This LED will be off when the Switch is no longer receiving power (i.e. powered
off).
This LED will light solid green when the console port is active.
This LED will be off when the console port is not active.
9