Configuring Threshold Of Local Training - HP FlexNetwork MSR Series Configuration Manual

Configuration prerequisites
VoIP configuration is completed, IP calls can be made successfully, and fax machines are connected
correctly.
Configuration procedure
To configure the fax training mode:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter voice entity view.
5. Configure a fax training
mode.
NOTE:
VoFR entities only support the PPP training mode.

Configuring threshold of local training

When rate training is carried on between fax terminals, the transmitting terminal transmits
"zero-filled" TCF data (the filling time per packet is 1.5±10% seconds) to the receiving fax terminal,
and the receiving fax terminal decides whether the current rate is acceptable according to the
received TCF data.
When the percentage of all-ones or all-zeros TCF data to the total number of TCP data is less than
the local training threshold, the current rate training succeeds. Otherwise, the current rate training
fails and you need to drop the rate for a local training operation again.
Configuration prerequisites
VoIP configuration is completed, IP calls can be made successfully, and fax machines are connected
correctly.
Configuration procedure
To configure the threshold percentage of local training:
Step
1. Enter system view.
2. Enter voice view.
3. Enter voice dial program
view.
4. Enter voice entity view.
5. Configure the fax training
mode.
6. Configure the threshold of
local training.
Command
system-view
voice-setup
dial-program
entity entity-number { pots | vofr
| voip }
fax train-mode { local | ppp }
Command
system-view
voice-setup
dial-program
entity entity-number { pots | vofr
| voip }
fax train-mode local
fax local-train threshold
threshold
277
Remarks
N/A
N/A
N/A
N/A
By default, the PPP training is
adopted.
Remarks
N/A
N/A
N/A
N/A
By default, the PPP training is
adopted.
By default, the threshold is 10.