Total number of cross-connections: 1
Total number of ACs: 2
AC
GE2/1/1
GE2/1/2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)
Configuring IP interworking over local MPLS L2VPN
connections
Network requirements
CE 1 and PE are connected through Ethernet interfaces. CE 2 and PE are connected through serial
interfaces, and use PPP as the link layer protocol.
Configure local MPLS L2VPN connections between PE and CEs and enable interworking on PE so
GigabitEthernet 2/1/1 on CE 1 can communicate with Serial 2/1/0 on CE 2.
Figure 98 Network diagram
Configuration procedure
1.
Configure CE 1.
<CE1> system-view
[CE1] interface gigabitethernet 2/1/1
[CE1-GigabitEthernet2/1/1] ip address 10.1.1.1 24
[CE1-GigabitEthernet2/1/1] quit
2.
Configure CE 2.
<CE2> system-view
[CE2] interface serial 2/1/0
[CE2-Serial2/1/0] link-protocol ppp
[CE2-Serial2/1/0] ip address 10.1.1.2 24
[CE2-Serial2/1/0] quit
3.
Configure PE:
# Enable L2VPN.
<PE> system-view
[PE] l2vpn enable
Xconnect-group
vpn1
vpn1
392
Link ID
0
1