Configuring Mbgp Route Redistribution; Configuring Default Route Redistribution Into Mbgp - HP MSR ASM Configuration Manual

Configuring MBGP route redistribution

MBGP can advertise routing information in the local AS to neighboring ASs. It redistributes such routing
information from IGP into its routing table rather than learns the information by itself.
Follow these guidelines when you configure MBGP route redistribution:
• The Origin attribute of routes redistributed into the MBGP routing table with the import-route
command is Incomplete.
The Origin attribute of routes injected into the MBGP routing table with the network command is
•
IGP.
The networks to be injected must exist in the local IP routing table, and using a routing policy makes
•
route control more flexible.
To configure MBGP route redistribution:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv4 MBGP address
family view.
4. Configure route redistribution
from another routing protocol.

Configuring default route redistribution into MBGP

Using only the import-route command cannot redistribute any default route into MBGP. This task enables
default route redistribution into the MBGP routing table.
To configure MBGP to redistribute a default route from another protocol:
Step
1. Enter system view.
2. Enter BGP view.
3. Enter MBGP address family
view.
Command
system-view
bgp as-number
ipv4-family multicast
•
Enable route redistribution from
another routing protocol:
import-route protocol
[ { process-id | all-processes }
[ allow-direct | med med-value
| route-policy
route-policy-name ] * ]
•
Inject a network into the MBGP
routing table:
network ip-address [ mask |
mask-length ] [ short-cut |
route-policy route-policy-name ]
Command
system-view
bgp as-number
ipv4-family multicast
203
Remarks
N/A
N/A
N/A
At least one of these methods is
required.
No route redistribution is
configured by default.
The allow-direct keyword is
available only when the specified
routing protocol is OSPF.
Remarks
N/A
N/A
N/A