Dialer Timer Warmup; Dialer-Group - HP VSR1000 Layer 2 - Wan Access Command Reference

Examples
# Set the wait-carrier timer to 100 seconds on interface Dialer 0.
<Sysname> system-view
[Sysname] interface dialer 0
[Sysname-Dialer0] dialer timer wait-carrier 100

dialer timer warmup

Use dialer timer warmup to configure the warm-up timer for dynamic route backup.
Use undo dialer timer warmup to restore the default.
Syntax
dialer timer warmup delay
undo dialer timer warmup
Default
The warm-up timer is 30 seconds, or dynamic route backup takes effect 30 seconds after a system reboot.
Views
System view
Predefined user roles
network-admin
Parameters
delay: Sets the warm-up timer for dynamic route backup, in the range of 0 to 66635 seconds.
Usage guidelines
The warm-up timer for dynamic route backup starts upon system reboot, and before it expires, the
dynamic route backup function is disabled and the system cannot dial a secondary link even if the
corresponding primary link is down. If the primary link has not gone up when the timer expires, the
system dials the secondary link. After the primary link goes up, the system switches over to it.
Examples
# Set the warm-up timer to 20 seconds for dynamic route backup.
<Sysname> system-view
[Sysname] dialer timer warmup 20

dialer-group

Use dialer-group to assign an interface to a dialer access group.
Use undo dialer-group to restore the default.
Syntax
dialer-group group-number
undo dialer-group
Default
A dialer interface does not belong to any dialer access group.
34