Configuring Reverse Charging Function; Enabling The Router To Treat Disconnect Messages With Pi 8 As Standard Disconnect Messages - HP FlexNetwork MSR Series Configuration Manual

Configuring reverse charging function

Typically, the calling party is charged to place a call to the called party. If you want to charge the
called party, you can configure a prefix to match the called number for reverse charging.
After you configure this function, the router identifies a reverse-charge call by comparing the called
number of an incoming call with a prefix. If the called number matches the prefix, the router interacts
with the PBX device to charge the called party.
If you configure the reverse charging function in both voice view and digital voice subscriber line view,
the configuration in digital voice subscriber line view takes effect.
To configure the reverse charging function in voice view:
Step
1. Enter system view.
2. Enter voice view.
3. Configure a prefix for
reverse charging.
To configure the reverse charging function in digital voice subscriber line view:
Step
1. Enter system view.
2. Enter digital voice subscriber
line view.
3. Configure a prefix for
reverse charging.
NOTE:
Support for the reverse charging function depends on the voice card.
Enabling the router to treat DISCONNECT
messages with PI 8 as standard DISCONNECT
messages
When the router receives a standard DISCONNECT message, it brings down the user-side
B-channel, sends a RELEASE message, and disconnects the call. When it receives a
DISCONNECT message with Progress Indicator (PI) 8, it brings up the B-channel to receive inband
information. The router does not disconnect the call or release the B-channel until it receives a
standard DISCONNECT message.
To avoid unnecessarily occupying B-channel resources, enable the router to treat DISCONNECT
messages with PI 8 as standard DISCONNECT messages.
To enable the router to treat DISCONNECT messages with PI 8 as standard DISCONNECT
messages:
Step
1. Enter system view.
Command
system-view
voice-setup
reverse-charge prefix string
Command
system-view
subscriber-line line-number
reverse-charge prefix string
Command
system-view
90
Remarks
N/A
N/A
By default, no prefix for reverse
charging is configured.
Remarks
N/A
N/A
By default, no prefix for reverse
charging is configured.
Remarks
N/A