Cli Error Messages; Command Line Interface (Cli) Variations; Bootloader Cli - Proxim ORiNOCO AP-2500 User Manual

Using the Command Line Interface

CLI Error Messages

The following table describes the error messages associated with improper inputs or expected CLI behavior.
Error Message
% Syntax error
% Invalid command
% Invalid parameter name
% Invalid parameter value
% Invalid table index
% Invalid table parameter
% Invalid table parameter value
% Read only parameter
% Incorrect password
% Download unsuccessful
% Upload unsuccessful

Command Line Interface (CLI) Variations

Administrators use the CLI to control Access Point operation and monitor network statistics. The AP-2500 supports
two types of CLI: the Bootloader CLI and the normal CLI. The Bootloader CLI provides a limited command set, and is
used when the current AP Image is bad or missing. The Bootloader CLI allows you to assign an IP Address and
download a new image. Once the image is downloaded and running, the Access Point uses the normal CLI. This guide
covers the normal CLI unless otherwise specified.

Bootloader CLI

The Bootloader CLI is a minimal subset of the normal CLI used to perform initial configuration of the AP-2500 device.
This interface is only be accessible via the serial interface if the AP-2500 unit does not contain an image (binary) or the
TFTP operation has failed as result of the download command for an image.
The Bootloader CLI provides you with the ability to configure the initial setup parameters as well as download an
image (binary) to the device.
The Bootloader CLI supports the following functions:
– configuration of initial device parameters using the set command
– show command to view the device's configuration parameters
– help command to provide additional information on all commands supported by the Bootloader CLI
– reboot command to reboot the device.
The parameters supported by the Bootloader CLI (for viewing and modifying) are:
– System Name
– IP Address Assignment Type
– IP Address
– IP Mask
– Gateway IP Address
– TFTP Server IP Address
– Image (binary) File Name
Description
Invalid syntax entered at the command prompt.
A non-existent command has been entered at the command prompt.
An invalid parameter name has been entered at the command prompt.
An invalid parameter value has been entered at the command prompt.
An invalid table index has been entered at the command prompt.
An invalid table parameter has been entered at the command prompt.
An invalid table parameter value has been entered at the command prompt.
User is attempting to configure a read-only parameter.
An incorrect password has been entered in the CLI login prompt.
The download operation has failed due to incorrect TFTP server IP Address or file name.
The upload operation has failed due to incorrect TFTP server IP Address or file name.
186