Troubleshooting; How To Obtain Help With Your Lan Installation; Led Error Codes - Proxim Harmony 8550 Manual

Hide thumbs Also See for Harmony 8550:

Table of Contents

The Harmony 802.11b Access Point is designed to be very easy to install and operate.

However, if you experience difficulties, use the information in this chapter to help

diagnose and solve problems.

Also, refer to the Harmony Access Point Controller Model 7560 User's Guide if you are

using the Access Point in Dependent mode for additional troubleshooting suggestions.

If you cannot resolve a problem, contact Proxim Technical Support, as described in

Appendix D, "How to Reach Technical Support."

If you require assistance to install your LAN, Proxim can put you in contact with a

Harmony reseller in your area. The reseller is an expert in the design, installation, and

maintenance of LANs and will be able to examine your needs and recommend the most

cost-effective solution for your LAN, whether you are installing a new LAN or adding

on to an existing one. For the location of the Harmony reseller nearest you, contact

Proxim at 1-800-229-1630 and ask for the Sales Department.

The Status LED, located on the top of the Harmony 802.11b Access Point, will flash red

in a repeating pattern to indicate the following errors:

1 blink: Memory error

2 blinks: Flash write error

3 blinks: Ethernet initialization error

4 blinks: Radio initialization error

If you see any of the above flashing sequences, recycle power to the Access Point. If the

flashing sequence persists after you have reset the unit, make a note of which of the

above patterns you have and contact Proxim Technical Support.

9. Troubleshooting

Table of Contents

Harmony 8551