Vlan Access-Map - Allied Telesis x510-28GTX Command Reference Manual

VLAN C
OMMANDS
-
VLAN ACCESS MAP

vlan access-map

Overview Use this command to create a VLAN access-map and enter into VLAN access-map
mode, so you can add ACLs to the map. You can use any IPv4 or IPv6 hardware
ACLs. VLAN access-maps are used to attach ACLs to VLANs, and therefore to filter
traffic as it ingresses VLANs.
See the
including information about the number of rules consumed by per-VLAN ACLs,
and ACL processing order.
Use the no variant of this command to delete a VLAN access-map.
vlan access-map <name>
Syntax
no vlan access-map <name>
Default By default, no VLAN access-maps exist.
Mode Global Configuration
Example To apply ACL 3001 to VLAN 48, where the ACL drops IP traffic from any source to
any destination, use the commands:
awplus#
awplus(config)#
awplus(config)#
awplus(config-vlan-access-map)#
awplus(config-vlan-access-map)#
awplus(config)#
Related match access-group
Commands
show vlan access-map
vlan filter
Command Version 5.4.6-2.1: command added
changes
C613-50170-01 Rev B
ACL Feature Overview and Configuration Guide
Parameter Description
<name>
A name for the access-map.
configure terminal
access-list 3001 deny ip any any
vlan access-map deny_all
vlan filter deny_all vlan-list 48 input
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
for more information,
match access-group 3001
exit
610