Pos : 31.1 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung (alte Str uktur)/Ansc hlüs se/Fel dbus koppl er/-contr oller/F eldbus ans chl uss - Ü berschrift 3 @ 5\mod_1245071569213_21.doc x @ 35313 @ 3 @ 1

4.2.2

Fieldbus Connection

Pos : 31.2 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung (alte Str uktur)/Ansc hlüs se/Fel dbus koppl er/-contr oller/Anschl uss Fel dbus über z wei RJ-45-Stec kver binder mi t 2- Por t-Switc h - Einl eitung ( 750-330, - 352) @ 7\mod_1265900853619_21.doc x @ 50392 @ @ 1

The connection to the fieldbus is made via two RJ-45 plugs, which are connected

to the fieldbus controller via an integrated switch.

The integrated switch works in store-and-forward operation and for each port,

supports the transmission speeds 10/100 Mbit as well as the transmission

modes full and half-duplex and autonegotiation.

Pos : 31.3 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung (alte Str uktur)/Ansc hlüs se/Fel dbus koppl er/-contr oller/Di e Bes chaltung der RJ-45-Buc hsen sind entspr ec hend den Vorgaben für 100BaseTX - Besc hrei bung, Kabel @ 5\mod_1245073028195_21.doc x @ 35336 @ @ 1

The wiring of these plugs corresponds to the specifications

for 100BaseTX, which prescribes a category 5 twisted pair cable as the

connecting cable. Cable types S/UTP (Screened Unshielded Twisted Pair) and

STP (Shielded Twisted Pair) with a maximum segment length of 100 m

(approximately 328.08 feet) can be used.

Pos : 31.4 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung (alte Str uktur)/Ansc hlüs se/Fel dbus koppl er/-contr oller/Di e Ans chl usss tell e ist so konzi piert, dass Ei nbau i n einen 80 mm hohen Schaltsc hrank möglich ist. @ 5\mod_1245073401892_21.doc x @ 35339 @ @ 1

The socket is arranged physically lower, allowing the coupler to fit in an 80 mm

high enclosure after plug connection.

Pos : 31.5 /Serie 750 (WAGO-I/O-SYST EM)/Ger ätebesc hrei bung (alte Str uktur)/Ansc hlüs se/Fel dbus koppl er/-contr oller/T abell e, Abbildung, Busansc hlus s und Stec kerbelegung RJ- 45- Stec ker @ 5\mod_1245073518124_21.doc x @ 35342 @ @ 1

Figure 26: RJ-45 Connector

Table 12: RJ-45 Connector and RJ-45 Connector Configuration

Contact

Pos : 31.6 /All e Seri en ( Allgemei ne Module)/Sicherheits- und s ons tige Hi nweis e/Ac htung/Achtung: Nic ht in Tel ekommuni kations netzen eins etzen! (Zus atz RJ-45) @ 3\mod_1224065187468_21.doc x @ 24076 @ @ 1

Do not use in telecommunication circuits!

Only use devices equipped with ETHERNET or RJ-45 connectors in LANs.

Never connect these devices with telecommunication networks.

Pos : 32 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1

Manual

Version 1.3.0

Signal

TD +

Transmit +

TD −

Transmit −

RD +