Plc Runtime Information" Page; Table 61: Wbm "Plc Runtime Information" Page - "Runtime" Group - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100

15.1.1.1.3 "PLC Runtime Information" Page

All information about the enabled runtime system and PLC program created in
the programming software is provided on the "PLC Runtime Information" page.
You will also find a link here to open WebVisu.
"Runtime" Group
Table 61: WBM "PLC Runtime Information" Page – "Runtime" Group
Parameter
Version
Webserver Version
State
Number of Tasks
"WebVisu" Group
You will find a link that you can use to open WebVisu.
Explanation
The version of the currently enabled runtime system
is shown.
If the runtime system is disabled, "None" is
displayed and the subsequent fields of this group
are hidden.
This shows the version number of the Webserver.
This field appears if the controller supports the
CODESYS V2 runtime system and CODESYS V2 is
set as the runtime system.
The PLC operating state is displayed.
This field appears if the controller supports the
CODESYS V2 runtime system and CODESYS V2 is
set as the runtime system.
STOP PLC program is not executed.
RUN PLC program is executed.
The number of tasks in the PLC program is shown.
This field appears if the controller supports the
CODESYS V2 runtime system and CODESYS V2 is
set as the runtime system.
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 127
Manual