Ending Service Mode; Backing Up Service Mode - Canon Image Reader-A1 iR5000i Service Manual

1.3 Ending Service Mode

Press the Reset key once to return to the service mode Initial screen (F05-102-01).
Press the Reset key twice to end service mode and to return to the User (standard) screen.
If you used ADJUST, FUNCTION, or OPTION in service mode, be sure to
turn off and then on the power switch after ending service mode.

1.4 Backing Up Service Mode

Each machine is adjusted before shipment from the factory, and adjustment settings are
indicated on the service label (attached to the service book case found behind the front
cover).
The service label of the reader unit is attached behind the reader rear upper cover.
If you have replaced the reader controller PCB or the DC controller PCB, be sure to re-
move the EEPROM from the old PCB and mount it to the new PCB.
If you have initialized the RAM, the ADJUST and OPTION settings are replaced with the
default settings. If you have made adjustments and changed service mode settings in the
field, be sure to record the new settings on the service label. (If the label does not show an
appropriate item, make use of its blank space.)
If you want, you can print out all service mode settings at once using service mode
(COPIER>FUNCTION>MIS-P>P-PRINT).
COPYRIGHT © 2001 CANON INC.
Service Label
F05-104-01 Service Label
2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 5 SERVICE MODE
5-3 T