Table of Contents
Advertisement
2. ADJUSTMENT / SETTINGS
2-1. Service Mode
(1) Service mode operation procedures
Use the Service Tool on the connected computer.
1) Start the machine in the service mode.
MG2100 series, MG2200 series, MG3100 series, MG3200 series:
i.
With the machine power turned off, while pressing the Stop/Reset button, press and hold the ON
button. (DO NOT release the buttons).
ii.
When the Plain Paper LED lights in green, while holding the ON button, release the Stop/Reset
button.
iii.
While holding the ON button, press the Stop/Reset button 5 times
(Each time the Stop/Reset button is pressed, the Alarm and Plain Paper LEDs light alternately,
Alarm in orange and Plain Paper in green)
iv. When the Plain Paper LED lights in green, the machine is ready for the service mode operation.
*1:
To disable the scanner error detection and start the machine in the service mode, press the Stop/Reset button 6
times. This way, the service mode is available without the scanner.
MG4100 series, MG4200 series:
i.
With the machine power turned off, while pressing the Stop button, press and hold the ON button.
(DO NOT release the buttons.)
ii.
When the Power LED lights in blue, while holding the ON button, release the Stop button.
iii.
While holding the ON button, press the Stop button 5 times
time the Stop button is pressed, the Alarm and Power LEDs light alternately, Alarm in orange and
Power in blue.)
iv. When the Power LED lights in blue, the machine is ready for the service mode operation.
*1:
To disable the scanner error detection and start the machine in the service mode, press the Stop button 6 times.
This way, the service mode is available without the scanner.
2) Start the Service Tool on the connected computer.
i.
When a button is clicked in the Service Tool dialog box, that function is performed. During
operation of the selected function, all the Service Tool buttons are dimmed and inactive.
ii.
When the operation is completed, "A function was finished." is displayed, and another function can
be selected.
iii.
If a non-supported function is selected, "Error!" is displayed. Click OK in the error message dialog
box to exit the error.
*1
, and release the ON button. (Each
(9/34)
easyfixs.blogspot.com
*1
, and release the ON button.
Hide quick links:
Advertisement
Table of Contents
