Duplex Unit; Removing The Duplex Unit; Removing The Reversing Flapper Solenoid; Removing The Reversal Motor - Canon Image Reader-A1 iR5000i Service Manual

CHAPTER 5 PICK UP/FEEDING SYSTEM

9.6 Duplex Unit

9.6.1 Removing the Duplex Unit

1) Slide the duplex unit out of the ma-
chine.
2) Remove the three screws [1] and two
knobs [2]; then, detach the front cover
[3].
3) Holding the left and right grips [4] of
the duplex unit, take it out of the ma-
chine.
Take care not to trap your hand
between the grip and the rail.
Further, do not place the duplex
unit where it may suffer dam-
age.

9.6.2 Removing the Reversing Flapper Solenoid

1) Remove the duplex unit from the ma-
chine.
2) Disconnect the connector [1], and free
the harness [3] from the guide [2].
3) Remove the two mounting screws [4],
and detach the reversing flapper sole-
noid [5].
(The steps of installation refer to 9.6.17
"Mounting the Reversing Flapper
solenoid".)

9.6.3 Removing the Reversal Motor

1) Remove the front cover of the duplex
unit.
2) Disconnect the connector [1].
3) Remove the three mounting screws [2],
and detach the reversal motor [3] to-
gether with its support plate.
5-70 P
COPYRIGHT © 2001 CANON INC.
[4]
F05-906-01
[1]
[2]
F05-906-02
[2] [1]
[2]
F05-906-03
2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
[2]
[4]
[3]
[1]
[4]
[3] [4] [5]
[3] [2]