Canon Image Reader-A1 iR5000i Service Manual page 307

3) Free a length of about 5 cm of charging
wire from the charging wire reel (0.06
mm in diameter), and form a loop at its
end with a diameter of about 2 mm.
To form a loop, wind the charg-
ing wire around a hex key once,
REF.
and turn the hex key three to
four times; then, twist the charg-
ing wire.
4) Cut the end (excess) of the twisted
charging wire.
5) Hook the loop on the stud.
6) At the rear, hook the charging wire on
the charging wire positioner; then, hook
the charging wire tension spring on the
charging wire where indicated to F04-
708-04.
COPYRIGHT © 2001 CANON INC. 2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
CHAPTER 4 IMAGE FORMATION SYSTEM
Reel
Stud
(front) Charging wire
F04-708-03
F04-708-04
Charging electrode
(rear)
4-67 P