Canon Image Reader-A1 iR5000i Service Manual page 571

Contents
CHAPTER 1 MAINTENANCE AND INSPECTION
1. Periodically Replaced Parts ........... 1-1T
1.1 Guide to Timing of
Replacement ............................. 1-1T
1.2 Reader Unit .............................. 1-1T
1.3 Printer Unit ............................... 1-2T
2. Consumables and Durables ............ 1-3T
2.1 Guide to Timing of
Replacement ............................. 1-3T
2.2 Reader Unit .............................. 1-3T
2.3 Printer Unit ............................... 1-4T
CHAPTER 2 IMAGE ADJUSTMENT BASIC PROCE-
1. Making Pre-Checks ....................... 2-1T
2. Making Checks on the Printer Unit
(1/2) .............................................. 2-2T
CHAPTER 3 STANDARDS AND ADJUSTMENTS
1. Image Adjustments ........................ 3-1T
1.1 Standards of Image Position ... 3-1T
1.2 Checking the Image Position .. 3-2T
1.3 Adjusting the Left/Right
Image Margin ........................... 3-2T
1.3.1 Cassette 3/4 ........................ 3-2T
1.3.2 Left/Right Front Deck ........ 3-3T
1.3.3 Manual Feed Tray .............. 3-3T
1.3.4 Duplex Feeding Unit .......... 3-4T
1.3.5 Side Paper Deck ................. 3-4T
1.4 Adjusting the Image Leading
Edge Margin ............................. 3-5T
1.5 Adjusting the Left/Right
Non-Image Width ................... 3-5T
COPYRIGHT © 2001 CANON INC.
DURE
2000 2000 2000 2000 CANON iR5000i/iR6000i REV.0 JUNE 2001
2.4 Side Paper Deck ....................... 1-5T
3. Periodical Servicing ........................ 1-6T
4. Periodical Servicing Chart .............. 1-9T
4.1 Reader Unit .............................. 1-9T
4.2 Printer Unit ............................... 1-9T
5. Points to Note for Periodical
Servicing ....................................... 1-12T
6. Cleaning the photosensitive
drum ............................................. 1-13T
3. Making Checks on the Printer Unit
(2/2) ............................................... 2-3T
4. Making Checks on the Reader
Unit ................................................. 2-4T
1.6 Adjusting the Leading Edge Non-
Image Width ............................ 3-6T
2. Scanning System ........................... 3-7T
2.1 Replacing the Scanner Drive
Cable ........................................ 3-7T
2.2 Adjusting the Position of the
Scanner Mirror Base ................ 3-7T
2.3 After Replacing the Scanning
Lamp ........................................ 3-7T
3. Image Formation System ................ 3-8T
3.1 Routing the Grid Wire of the
Primary Charging Assembly .... 3-8T
3.2 Routing the Charging Wire of
Charging Assemblies ................ 3-8T
CONTENTS
T 1