Beeper - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
To edit compliance limit values:
1. Press the LIMIT key.
2. Use the CURSOR keys (or turn the navigation wheel
needs to be changed.
3. Press the navigation wheel or the ENTER key to enter edit mode. The EDIT indicator is
illuminated.
4. Change the compliance value (see
5. When finished, press the ENTER key (the EDIT indicator is not illuminated).
The up and down range keys change the format of the limit value.

Beeper

The Series 2600B includes a beeper. When it is enabled, a beep indicates one of the following
actions have occurred:
•
A front-panel key was pressed: A short beep, similar to a key click, is issued.
•
The navigation wheel
•
The output source was changed: A longer beep is issued when you press the OUTPUT ON/OFF
control (turn the output on or off).
To turn the beeper on or off from the front panel:
1. Press the MENU key, and then select BEEPER.
2. Select one of the following:
• ENABLE
• DISABLE
To turn the beeper on or off from the TSP command interface:
Set the beeper.enable attribute. For example, to enable the beeper, send:
beeper.enable = 1
2600BS-901-01 Rev. B / May 2013
Setting values
was turned or pressed: A short beep is issued.
Section 2: General operation
) to move the cursor to the digit that
(on page 2-21)).
2-23