Smux.cal.due - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
Usage
calDate = smuX.cal.date
smuX.cal.date = calDate
calDate
X
Details
This attribute stores the calibration date that is associated with the active calibration set. The calibration date can
be read at any time but can only be assigned a new value when calibration has been enabled with the
smuX.cal.unlock() function. It is typically set to the date when the instrument was calibrated.
This attribute is stored with the active calibration set. If a different calibration set is restored, this attribute will
reflect the date stored with that set.
smuX.cal.date must be set to the date the calibration was done using the UTC time and date. The date is
stored as the number of seconds since UTC 12:00 am Jan 1, 1970.
Due to the internal storage format, smuX.cal.date is accurate to within a few minutes of the value set.
Example
smua.cal.date = os.time()
Also see
Adjustment
os.time()
smuX.cal.adjustdate

smuX.cal.due

smuX.cal.lock()
smuX.cal.restore()
smuX.cal.save()
smuX.cal.state
smuX.cal.unlock()
smuX.cal.due
This attribute stores the calibration due date for the next calibration.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
calDue = smuX.cal.due
smuX.cal.due = calDue
calDue
X
2600BS-901-01 Rev. B / May 2013
The calibration date of the active calibration set
Source-measure unit (SMU) channel (for example, smua.cal.date applies to
SMU channel A)
(on page B-18)
(on page 7-151)
(on page 7-184)
(on page 7-185)
(on page 7-186)
(on page 7-188)
(on page 7-189)
(on page 7-189)
(on page 7-190)
Affected by
SMU cal. restore
Due date of next calibration (0 indicates that no date is set)
Source-measure unit (SMU) channel (for example, smua.cal.due applies to
SMU channel A)
Section 7: TSP command reference
Sets calibration date for SMU channel A to the current time
set on the instrument.
Where saved Default value
SMU nonvolatile 0
memory
7-185