Lan.config.speed; Lan.config.subnetmask - Keithley 2601B Reference Manual

Section 7: TSP command reference
Example
print(lan.config.method)
Also see
lan.restoredefaults()

lan.config.speed

This attribute contains the LAN speed used when restarting in manual configuration mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
speed = lan.config.speed
lan.config.speed = speed
speed
Details
This attribute stores the speed that will be used if the LAN is restarted for manual configuration operation.
This attribute does not indicate the actual setting presently in effect. Use the lan.status.speed attribute to
determine the present operating state of the LAN.
The LAN speed is measured in megabits per second (Mbps).
Example
lan.config.speed = 100
Also see
lan.restoredefaults()
lan.status.speed

lan.config.subnetmask

This attribute contains the LAN subnet mask.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
mask = lan.config.subnetmask
lan.config.subnetmask = mask
mask
7-118
(on page 7-121)
Affected by
LAN restore defaults
LAN speed setting in Mbps (10 or 100)
(on page 7-121)
(on page 7-127)
Affected by
LAN restore defaults
String that specifies the LAN subnet mask value in dotted decimal notation
Series 2600B System SourceMeter® Instrument Reference Manual
Outputs the current method.
For example:
1.00000e+00
Where saved
Nonvolatile memory
Configure LAN speed for 100.
Where saved
Nonvolatile memory
Default value
100 (100 Mbps)
Default value
"255.255.255.0"
2600BS-901-01 Rev. B / May 2013