Series 2600B System SourceMeter® Instrument Reference Manual
Setting the IP address
Contact your corporate information technology (IT) department to secure a valid IP address for the
instrument when placing the instrument on a corporate network.
To set the IP address (when LAN configuration method is set to MANUAL):
1. From the front panel, press the MENU key, and then select LAN > CONFIG > IP-ADDRESS.
2. Turn the navigation wheel
3. Press the ENTER key to confirm the changes.
4. Press the EXIT (LOCAL) key twice to return to the LAN CONFIG menu.
5. Select APPLY_SETTINGS > YES, and then press the ENTER key.
Setting the gateway
Contact your corporate information technology (IT) department to secure a valid gateway for the
instrument when placing the instrument on a corporate network.
To set the gateway (when LAN configuration method is set to MANUAL):
1. From the front panel, press the MENU key, and then select LAN > CONFIG > GATEWAY.
2. Turn the navigation wheel
3. Press the ENTER key to confirm the changes.
4. Press the EXIT (LOCAL) key twice to return to the LAN CONFIG menu.
5. Select APPLY_SETTINGS > YES, and then press the ENTER key.
Setting the subnet mask
Contact your corporate information technology (IT) department to secure a valid subnet mask for the
instrument when placing the instrument on a corporate network.
To set the subnet mask (when LAN configuration method is set to MANUAL):
1. From the front panel, press the MENU key, and then select LAN > CONFIG > SUBNETMASK.
2. Turn the navigation wheel
3. Press the ENTER key to confirm the changes.
4. Press the EXIT (LOCAL) key twice to return to the LAN CONFIG menu.
5. Select APPLY_SETTINGS > YES, and then press the ENTER key.
2600BS-901-01 Rev. B / May 2013
to select and enter a valid IP address for the instrument.
to select and enter a valid gateway address for the instrument.
to select and enter a valid subnet mask for the instrument.
Appendix C: LAN concepts and settings
C-11