Status.node_Enable - Keithley 2601B Reference Manual

Section 7: TSP command reference
Bit Value
B0 Not used
B1
status.measurement.voltage_limit.SMUA
B2 status.measurement.voltage_limit.SMUB
B3-B15 Not used
As an example, to set bit B1 of the measurement event voltage limit summary enable register, set
status.measurement.voltage_limit.enable = status.measurement.voltage_limit.SMUA.
In addition to the above constants, measurementRegister can be set to the decimal equivalent of the bit to
set. To set more than one bit of the register, set measurementRegister to the sum of their decimal weights.
For example, to set bits B1 and B2, set measurementRegister to 6 (which is the sum of 2 + 4).
Example
status.measurement.voltage_limit.enable =
status.measurement.voltage_limit.SMUA
Also see
Measurement event registers

status.node_enable

This attribute stores the system node enable register. This attribute is not available on the Models
2604B/2614B/2634B.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
nodeEnableRegister = status.node_enable
status.node_enable = nodeEnableRegister
nodeEnableRegister The status of the system node enable register; a zero (0) indicates no bits set (also
7-266
Series 2600B System SourceMeter® Instrument Reference Manual
(on page E-8)
Affected by
Status reset
send 0 to clear all bits); other values indicate various bit settings
Description
Not applicable.
Set bit indicates the enabled VLMT bit for the
SMU A measurement register is set.
Bit B1 decimal value: 2
Binary value: 0000 0010
This bit is only available on Models
2602B/2604B/2612B/2614B/2634B/2636B. Set
bit indicates the enabled VLMT bit for the SMU
B measurement register is set.
Bit B2 decimal value: 4
Binary value: 0000 0100
Not applicable.
Sets the SMUA bit of the
measurement event voltage limit
summary enable register using a
constant.
Where saved Default value
Not saved 0
2600BS-901-01 Rev. B / May 2013