Status.operation.remote - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
As an example, to set bit B1 of the operation status measuring summary enable register, set
status.operation.measuring.enable = status.operation.measuring.SMUA.
In addition to the above constants, operationRegister can be set to the numeric equivalent of the bit to set.
To set more than one bit of the register, set operationRegister to the sum of their decimal weights. For
example, to set bits B1 and B2, set operationRegister to 6 (which is the sum of 2 + 4).
Example
status.operation.measuring.enable =
status.operation.measuring.SMUA
Also see
Operation Status Registers
status.operation.*

status.operation.remote.*

This attribute contains the operation status remote summary register set.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
Usage
operationRegister = status.operation.remote.condition
operationRegister = status.operation.remote.enable
operationRegister = status.operation.remote.event
operationRegister = status.operation.remote.ntr
operationRegister = status.operation.remote.ptr
status.operation.remote.enable = operationRegister
status.operation.remote.ntr = operationRegister
status.operation.remote.ptr = operationRegister
operationRegister
2600BS-901-01 Rev. B / May 2013
(on page E-9)
(on page 7-270)
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
The status of the operation status remote summary register; a zero (0) indicates no
bits set (also send 0 to clear all bits); other values indicate various bit settings
Section 7: TSP command reference
Uses a constant to set the SMUA bit
of the operation status measuring
summary enable register.
Where saved Default value
- - - -
Not saved Not applicable
Not saved 0
Not saved 0
Not saved 0
Not saved 2050 (All bits set)
7-297