Section 5: Introduction to TSP operation
LAN and LXI
The LAN commands have options that allow you to review and configure network settings.
The lan.config.* commands allow you to configure LAN settings over the remote interface. Note
that you must send lan.applysettings() for the configuration settings to take effect.
The lan.status.* commands help you determine the status of the LAN.
The lan.trigger[N].* commands allow you to set up and assert trigger events that are sent over
the LAN.
Other LAN commands allow you to reset the LAN, restore defaults, check LXI domain information,
and enable or disable the Nagle algorithm.
lan.applysettings()
lan.autoconnect
lan.config.dns.address[N]
lan.config.dns.domain
lan.config.dns.dynamic
lan.config.dns.hostname
lan.config.dns.verify
lan.config.duplex
lan.config.gateway
lan.config.ipaddress
lan.config.method
lan.config.speed
lan.config.subnetmask
lan.linktimeout
lan.lxidomain
lan.nagle
(on page 7-120)
lan.reset()
(on page 7-121)
lan.restoredefaults()
lan.status.dns.address[N]
lan.status.dns.name
lan.status.duplex
lan.status.gateway
lan.status.ipaddress
lan.status.macaddress
lan.status.port.dst
lan.status.port.rawsocket
lan.status.port.telnet
lan.status.port.vxi11
lan.status.speed
lan.status.subnetmask
lan.timedwait
lan.trigger[N].assert()
lan.trigger[N].clear()
lan.trigger[N].connect()
lan.trigger[N].connected
lan.trigger[N].disconnect()
lan.trigger[N].EVENT_ID
lan.trigger[N].ipaddress
lan.trigger[N].mode
lan.trigger[N].overrun
lan.trigger[N].protocol
lan.trigger[N].pseudostate
lan.trigger[N].stimulus
lan.trigger[N].wait()
localnode.description
localnode.password
5-8
(on page 7-111)
(on page 7-112)
(on page 7-112)
(on page 7-113)
(on page 7-114)
(on page 7-114)
(on page 7-115)
(on page 7-116)
(on page 7-116)
(on page 7-117)
(on page 7-117)
(on page 7-118)
(on page 7-118)
(on page 7-119)
(on page 7-120)
(on page 7-121)
(on page 7-122)
(on page 7-122)
(on page 7-123)
(on page 7-123)
(on page 7-124)
(on page 7-124)
(on page 7-125)
(on page 7-125)
(on page 7-126)
(on page 7-126)
(on page 7-127)
(on page 7-127)
(on page 7-128)
(on page 7-128)
(on page 7-129)
(on page 7-130)
(on page 7-130)
(on page 7-131)
(on page 7-131)
(on page 7-132)
(on page 7-133)
(on page 7-134)
(on page 7-134)
(on page 7-135)
(on page 7-135)
(on page 7-137)
(on page 7-138)
(on page 7-140)
Series 2600B System SourceMeter® Instrument Reference Manual
2600BS-901-01 Rev. B / May 2013