Smux.nvbuffery - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
Also see
smuX.measure.autorangeY
smuX.measure.Y()
smuX.source.autorangeY
smuX.trigger.source.limitY
smuX.trigger.source.linearY()
smuX.trigger.source.listY()
smuX.trigger.source.logY()
Sweep Operation

smuX.nvbufferY

This attribute contains a dedicated reading buffer.
Type TSP-Link accessible
Attribute (R) Yes
Usage
bufferVar = smuX.nvbufferY
bufferVar
X
Y
Details
Each SMU channel contains two dedicated reading buffers: smuX.nvbuffer1 and smuX.nvbuffer2.
All routines that return measurements can also store them in either reading buffer. Overlapped measurements
are always stored in a reading buffer. Synchronous measurements return either a single-point measurement or
can be stored in a reading buffer if passed to the measurement command.
The dedicated reading buffers can be saved to internal nonvolatile memory (to retain data between power
cycles) using the smuX.savebuffer() function.
Example
smua.measure.overlappedv(smua.nvbuffer1)
Also see
Configuring and running sweeps
Reading buffers
savebuffer()
smuX.makebuffer()
smuX.measure.overlappedY()
smuX.savebuffer()
smuX.trigger.measure.action
smuX.trigger.measure.set()
smuX.trigger.measure.stimulus
smuX.trigger.measure.Y()
2600BS-901-01 Rev. B / May 2013
(on page 7-198)
(on page 7-213)
(on page 7-217)
(on page 7-247)
(on page 7-248)
(on page 7-249)
(on page 7-250)
(on page 3-20)
Affected by
Not applicable
The dedicated reading buffer
Source-measure unit (SMU) channel (for example, smua.nvbuffer1 applies to
SMU channel A)
SMU nonvolatile buffer (1 or 2)
(on page 3-29)
(on page 3-6)
(on page 7-161)
(on page 7-197)
(on page 7-209)
(on page 7-216)
(on page 7-241)
(on page 7-241)
(on page 7-242)
(on page 7-244)
Section 7: TSP command reference
Where saved Default value
See Details
Not applicable
Store voltage readings from SMU channel A
into SMU channel A dedicated reading
buffer 1.
7-215