Status.operation.instrument.tsplink - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
Also see
Operation Status Registers
status.operation.instrument.trigger_timer.*

status.operation.instrument.tsplink.*

This attribute contains the operation status TSP-Link summary register set. This attribute is not available on the
Models 2604B/2614B/2634B.
Type TSP-Link accessible
Attribute - -
.condition (R) Yes
.enable (RW) Yes
.event (R) Yes
.ntr (RW) Yes
.ptr (RW) Yes
Usage
operationRegister = status.operation.instrument.tsplink.condition
operationRegister = status.operation.instrument.tsplink.enable
operationRegister = status.operation.instrument.tsplink.event
operationRegister = status.operation.instrument.tsplink.ntr
operationRegister = status.operation.instrument.tsplink.ptr
status.operation.instrument.tsplink.enable = operationRegister
status.operation.instrument.tsplink.ntr = operationRegister
status.operation.instrument.tsplink.ptr = operationRegister
operationRegister
Details
These attributes are used to read or write to the operation status TSP-Link summary registers. Reading a status
register returns a value. The binary equivalent of the returned value indicates which register bits are set. The
least significant bit of the binary number is bit B0, and the most significant bit is bit B15.
For information about .condition, .enable, .event, .ntr, and .ptr registers, refer to
page E-1) and
the following table.
Bit
B0-B9
B10
B11-B15
2600BS-901-01 Rev. B / May 2013
(on page E-9)
Affected by
- -
Not applicable
Status reset
Status reset
Status reset
Status reset
The status of the operation status TSP-Link summary register; a zero (0) indicates
no bits set (also send 0 to clear all bits); the only valid value other than 0 is 1024
Enable and transition registers
Value
Not used
status.operation.instrument.tsplink.TRIGGER_OVERRUN
status.operation.instrument.tsplink.TRGOVR
Not used
(on page 7-289)
Where saved
- -
Not saved
Not saved
Not saved
Not saved
Not saved
(on page E-19). The individual bits of this register are defined in
Section 7: TSP command reference
Default value
- -
Not applicable
0
0
0
1024 (All bits set)
Status register set contents
Description
Not applicable
Set bit indicates one or
more enabled bits for
the operation status
TSP-Link overrun
register is set.
Bit B10 decimal value:
1,024
Binary value:
0100 0000 0000
Not applicable
(on
7-293