Lan.status.dns.address[N]; Lan.status.dns.name - Keithley 2601B Reference Manual

Section 7: TSP command reference
Example
lan.restoredefaults()
Also see
lan.reset() (on page 7-121)
localnode.password

lan.status.dns.address[N]

This attribute contains the DNS server IP addresses.
Type TSP-Link accessible
Attribute (R) Yes
Usage
dnsAddress = lan.status.dns.address[N]
dnsAddress
N
Details
This attribute is an array of DNS server addresses. The instrument can use up to three addresses.
Unused or disabled entries are returned as "0.0.0.0" when read. The dnsAddress returned is a string
specifying the IP address of the DNS server in dotted decimal notation.
You can only specify two addresses manually. However, the instrument uses up to three DNS server addresses.
If two are specified, only the one given by a DHCP server is used. If no entries are specified, up to three address
given by a DHCP server are used.
The value of lan.status.dns.address[1] is referenced first for all DNS lookups. The values of
lan.status.dns.address[2] and lan.status.dns.address[3] are referenced second and third,
respectively.
Example
print(lan.status.dns.address[1])
Also see

lan.status.dns.name

lan.status.dns.name
This attribute contains the present DNS fully qualified host name.
Type TSP-Link accessible
Attribute (R) Yes
Usage
hostName = lan.status.dns.name
hostName
7-122
Series 2600B System SourceMeter® Instrument Reference Manual
(on page 7-140)
Affected by
Not applicable
DNS server IP address
Entry index (1, 2, or 3)
(on page 7-122)
Affected by
Not applicable
Fully qualified DNS host name that can be used to connect to the instrument
Restores the LAN defaults.
Where saved Default value
Not applicable Not applicable
Outputs DNS server address 1, for example:
164.109.48.173
Where saved Default value
Not applicable Not applicable
2600BS-901-01 Rev. B / May 2013