Lan.trigger[N].Pseudostate; Lan.trigger[N].Stimulus - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
Details
The LAN trigger listens for trigger messages on all supported protocols, but uses the designated protocol for
sending outgoing messages. After changing this setting, lan.trigger[N].connect() must be called before
outgoing event messages can be sent.
When the lan.MULTICAST protocol is selected, the lan.trigger[N].ipaddress attribute is ignored and
event messages are sent to the multicast address 224.0.23.159.
Example
print(lan.trigger[1].protocol)
Also see
lan.trigger[N].connect()
lan.trigger[N].ipaddress

lan.trigger[N].pseudostate

This attribute sets the simulated line state for the LAN trigger.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
pseudostate = lan.trigger[N].pseudostate
lan.trigger[N].pseudostate = pseudostate
pseudostate
N
Details
This attribute can be set to initialize the pseudo line state to a known value.
Setting this attribute does not cause the LAN trigger to generate any events or output packets.
Example
print(lan.trigger[1].pseudostate)
Also see
None

lan.trigger[N].stimulus

This attribute specifies events that cause this trigger to assert.
Type TSP-Link accessible
Attribute (RW) Yes
2600BS-901-01 Rev. B / May 2013
Get LAN protocol to use for sending trigger
messages for LAN event 1.
(on page 7-130)
(on page 7-132)
Affected by
Instrument reset
LAN trigger N reset
Recall setup
The simulated line state (0 or 1)
A number representing the LAN event number (1 to 8)
Affected by
Instrument reset
LAN trigger N reset
Recall setup
Section 7: TSP command reference
Where saved
Not saved
Get the present simulated line state for the LAN
event 1.
Where saved
Not saved
Default value
1
Default value
0
7-135