Tsp-Net Compared To Tsp-Link To Communicate With Tsp-Enabled Devices; Tsp-Net Instrument Commands: General Device Control; Tsp-Net Instrument Commands: Tsp-Enabled Device Control - Keithley 2601B Reference Manual

Section 6: Instrument programming
TSP-Net compared to TSP-Link to communicate with TSP-enabled
devices
The TSP-Link
communication occurs between the Series 2600B and another TSP-enabled instrument.
One of the advantages of using the TSP-Link network interface is that TSP-Link connections have
three synchronization lines that are available to each device on the TSP-Link network. You can use
any one of the synchronization lines to perform hardware triggering between devices on the TSP-Link
network. Refer to
However, if the distance between the Series 2600B and the TSP-enabled device is longer than
15 feet, use TSP-Net commands.

TSP-Net instrument commands: General device control

The following instrument commands provide general device control:
tspnet.clear()
tspnet.connect()
tspnet.disconnect()
tspnet.execute()
tspnet.idn() (on page 7-370)
tspnet.read()
tspnet.readavailable()
tspnet.reset()
tspnet.termination()
tspnet.timeout
tspnet.write()

TSP-Net instrument commands: TSP-enabled device control

The following instrument commands provide TSP-enabled device control:
tspnet.tsp.abort()
tspnet.tsp.abortonconnect
tspnet.tsp.rbtablecopy()
tspnet.tsp.runscript()
6-62
®
network interface is the preferred communication method for most applications where
Hardware trigger modes
(on page 7-366)
(on page 7-367)
(on page 7-368)
(on page 7-369)
(on page 7-370)
(on page 7-371)
(on page 7-372)
(on page 7-372)
(on page 7-373)
(on page 7-376)
(on page 7-374)
(on page 7-374)
(on page 7-375)
(on page 7-376)
Series 2600B System SourceMeter® Instrument Reference Manual
(on page 3-57) for details.
2600BS-901-01 Rev. B / May 2013