Keithley 2601B Reference Manual page 515

Series 2600B System SourceMeter® Instrument Reference Manual
Details
A new flow control setting takes effect when the command to change it is processed.
Allow ample time for the command to be processed before attempting to communicate with the
instrument again. If possible, set the flow control from one of the other command interfaces or from
the front panel.
The reset function has no effect on flow control.
Example
serial.flowcontrol = serial.FLOW_NONE
Also see
serial.baud
serial.databits
serial.parity
serial.parity
This attribute configures parity for the RS-232 port.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
parity = serial.parity
serial.parity = parity
parity
Details
A new parity setting takes effect when the command to change it is processed.
Allow ample time for the command to be processed before attempting to communicate with the
instrument again. If possible, set parity from one of the other command interfaces or from the front
panel.
The reset function has no effect on parity.
Example
serial.parity = serial.PARITY_NONE
2600BS-901-01 Rev. B / May 2013
(on page 7-173)
(on page 7-174)
(on page 7-175)
Affected by
Not applicable
Set parity to one of the following values:
•
Select no parity ("none" or serial.PARITY_NONE)
•
Select even parity ("even" or serial.PARITY_EVEN)
•
Select odd parity ("odd" or serial.PARITY_ODD)
Section 7: TSP command reference
Sets flow control to none.
Where saved Default value
Nonvolatile memory "none" (serial.PARITY_NONE)
Sets parity to none.
7-175