Lan.config.duplex; Lan.config.gateway - Keithley 2601B Reference Manual

Section 7: TSP command reference

lan.config.duplex

This attribute defines the LAN duplex mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
duplex = lan.config.duplex
lan.config.duplex = duplex
duplex
Details
This attribute does not indicate the actual setting currently in effect. Use the lan.status.duplex attribute to
determine the present operating state of the LAN.
Also see
lan.restoredefaults()

lan.config.gateway

This attribute contains the LAN default gateway address.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
gatewayAddress = lan.config.gateway
lan.config.gateway = gatewayAddress
gatewayAddress
Details
This attribute specifies the default gateway IP address to use when manual or DLLA configuration methods are
used to configure the LAN. If DHCP is enabled, this setting is ignored.
This attribute does not indicate the actual setting that is presently in effect. Use the lan.status.gateway
attribute to determine the present operating state of the LAN.
The IP address must be formatted in four groups of numbers, each separated by a decimal.
Example
print(lan.config.gateway)
Also see
lan.restoredefaults()
lan.status.gateway
7-116
Series 2600B System SourceMeter® Instrument Reference Manual
Affected by
LAN restore defaults
LAN duplex setting can be one of the following values:
1 or lan.FULL: Selects full-duplex operation
0 or lan.HALF: Selects half-duplex operation
(on page 7-121)
Affected by
LAN restore defaults
LAN default gateway address; must be a string specifying the default
gateway's IP address in dotted decimal notation
(on page 7-121)
(on page 7-123)
Where saved Default value
Nonvolatile memory 1 (lan.FULL)
Where saved Default value
Nonvolatile memory "0.0.0.0"
Outputs the default gateway address. For example,
you might see the output:
192.168.0.1
2600BS-901-01 Rev. B / May 2013