Resetting The Tsp-Link Network - Keithley 2601B Reference Manual

Series 2600B System SourceMeter® Instrument Reference Manual
To assign a node number using a remote command:
Set the tsplink.node attribute of the instrument:
tsplink.node = N
Where: N = 1 to 64
To determine the node number of an instrument, you can read the tsplink.node attribute by
sending the following command:
print(tsplink.node)
The above print command outputs the node number. For example, if the node number is 1, a 1 is
displayed.

Resetting the TSP-Link network

After all the node numbers are set, you must initialize the system by performing a TSP-Link
reset.
If you change the system configuration after initialization, you must reinitialize the system by
performing a TSP-Link network reset. Changes that require that you reinitialize the TSP-Link network
include turning off power or rebooting any instrument in the system, or rearranging or disconnecting
the TSP-Link cable connections between instruments.
Front panel operation
To reset the TSP-Link
1. Power on all instruments connected to the TSP-Link network.
2. Press the MENU key, select TSPLINK, and then press the ENTER key.
3. Turn the navigation wheel
Remote programming
The commands associated with the TSP-Link
TSP-Link reset commands
Command
tsplink.reset()
tsplink.state
An attempted TSP-Link reset operation will fail if any of the following conditions are true:
•
Two or more instruments in the system have the same node number
•
There are no other instruments connected to the instrument performing the reset (only if the
expected number of nodes was not provided in the reset call)
•
One or more of the instruments in the system is turned off
•
If the actual number of nodes is less than the expected number
2600BS-901-01 Rev. B / May 2013
®
network from the front panel:
to select RESET, and then press the ENTER key.
®
Description
Initializes the TSP-Link network
Reads the state of the TSP-Link network:
•
"online" if the most recent TSP-Link reset was
successful
•
"offline" if the reset operation failed
Section 6: Instrument programming
system reset are listed in the following table.
®
network
6-51